Climbing

The Beal Wall School is a 10.2mm climbing rope that has been designed to be used on indoor climbing walls in locations such as schools, colleges and youth clubs. This 10.2mm climbing rope has been designed to be easy to handle while also being very durable. Featuring a thicker than average sheath, this is then bonded to the inner core to prevent any slippage. The Beal Unicore process which achieves this still keeps the rope highly supple and easy to handle, even by smaller children.

The Twist Rental climbing harness by OCUN is an adjustable and robustly constructed harness that should fit most adults and has additional safety features. The tie-in loop and the transition to the leg and hip straps are contrasting in colour to emphasise the correct tie-in point. In addition, the gear loops are reinforced to hold up to 12.5 kN - enough for a climber to take a fall.

The Edelrid Zack Gym Climbing Harness has been designed for rental use, offering the perfect blend of comfort, durability, and ease of use. Fully adjustable to fit a wide range of body types, it’s ideal for beginner climbers at indoor gyms or climbing centres. With RFID chips for easy equipment tracking, it’s a reliable choice for both new climbers and busy rental fleets.

The DMM Centre Slidelock is a simple, durable and robust harness that features a new horizontal tie for increased durability. Designed for group use in outdoor and activity centres, the Centre Slidelock has colour coded safety points and stainless steel buckles for easy adjustment. The tie in/belay loop is positioned high for ease of access, whilst the yellow reinforcing tape helps to ensure attachment at the correct point.

The Beal Wall Cruiser 9.6mm Unicore is intended for use in indoor climbing and is a light but strong rope ideal for young climbers. The diameter of this rope is suitable for beginners and makes it easier to place in the belay device. Thanks to its thinness and manoeuvrability it can also be appreciated by experienced climbers. Wall Cruiser is also equipped with the Unicore process which glues the core to the sheath of the rope and limits sheath slippage. All this for greater durability and strength over time.

The Edelrid Ultralight III Junior is an extremely tough and durable climbing helmet. It features plenty of adjustment, making it ideal for use on high ropes courses and outdoor education centres.

The DMM Centre Threadback is a robust harness that's ideal for group and activity centre use. They are easy to put on correctly thanks to handy colour coding and the tie-in/belay loop is positioned high for ease of access, with safety point colour coding and threadback stainless buckles.

The Lyon Boulder Setter Magnetic Wrist Cuff has been designed for route setters, by route setters with over 30 years of combined route setting experience. Made with a 1000D abrasion resistant fabric outer and breathable spacer fabric on the inner, this cuff has been designed to ensure the highest quality in maintained throughout. It has a Velcro fastener that accommodates all wrist sizes and for ease of fitting and removing with one hand, as well as three strong Neodymium magnetic strips on the top of the wrist to accommodate drill bits and screws for easy access and to avoid loosing these item.

The Beal Rope Marker Ink is a specially formulated ink from rope maker Beal for marking climbing ropes safely. The ink has minimal effect on the rope, yet is permanent and resistant to water and abrasion. It does not affect polyamide at all. The container has a small roller at the tip for better inking. This ink is the only safe ink to use with climbing ropes and PPE soft equipment as standard inks, that generally contain solvents, may damage or corrode the rope fibres.